![]() Although the RxMux will default to Input A in the absence of any Select input signal, this is not a reliable failure mode. By itself, the RxMux does not perform any failsafe, redundancy, or protection services. The RxMux is best used as a component in a well planned system. When no servo signal is detected at the Select input, the RxMux will default to connecting Input A to the Output. ![]() A servo signal wider than 1.5ms will send connected signals at Input B to the Output. When a servo signal less than 1.5ms wide is detected, signals connected to Input A are sent to the Output. Switching between the two sources is accomplished by sending the appropriate width servo signal on the Select input channel (Input A, Channel 8). Standard R/C servos are connected to the Output. Signal sources such as R/C receivers, autopilots, microcontrollers, etc. The RxMux allows control of a set of R/C servos from two different signal sources. Signal sources can come from R/C receivers, autopilots or microcontrollers that are connected to the RxMux input pins. ![]() The RxMux allows control of 8 R/C servos from two different input signal sources. ![]() The RxMux is a specialized multiplexer that uses R/C servo signals as a basis for input control and output signals. For our complete selection on servos, DC motors and stepper motor, please visit our motor selection page.ĭRIVER-RxMux - RC Control Mux - US$99.00 This page contains all drivers that can be used to drive DC motor, servos, and stepper motors. Robot Store (HK) - MIT Handyboard system, OOPIC, Dr Robot kits, robot parts, robot kits, sensors, DC motors, gearbox, gear box, solar battery, stepper motor, wheel, tire, robot parts, RF module, digital compass, sonar, Tamiya models, OWI kits, Elkits ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |